How BaitFuel Disperses Underwater

BaitFuel emits a concentrated scent stream that quickly diffuses through the water column to draw fish toward your bait.

How to assemble and use

Injector setup instructions (PDF)
Reusing Scent Canisters (PDF)

Injector setup instructions

1. Twist and remove the injector cap.
2. Take the injector needles and the canister nozzle out of the injector tube.
3. Peel off the scent canister sticker, remove its cap and discard them.
4. Press the canister nozzle into the injector tube until it snaps into the two alignment notches.
5. Insert a full BaitFuel scent canister into the injector tube with the nozzle oriented opposite the plunger.
6. Screw the injector cap back onto the tube.
7. Rotate the plunger to the “closed” position — check the marking at the top of the plunger. Do not push down while turning.
8. Fit the needle onto the injector while the needle safety cap is on and press to seat it. The safety cap must remain on so there is enough pressure to hold the needle in place.
9. Remove the safety cap, unlock the plunger by turning it counterclockwise, and inject BaitFuel into your preferred baits.

Reusing Scent Canisters

1. Remove the empty scent canister from the injector tube.
2. Detach the canister nozzle.
3. Using a rod or similar tool, push the piston back to the bottom of the canister.
4. Refill the canister with BaitFuel gel scent attractant.
5. Reinstall the canister nozzle.
6. Place the refilled canister back into the injector and resume use.